Free Shipping 4 Channel 1 Speed Hoist Crane Truck Radio Remote Control Push Button Switch System with E Stop

Free Shipping 4 Channel 1 Speed Hoist Crane Truck Radio Remote Control Push Button Switch System with E Stop
  • Продавецwww.flimmer.com
  • Список ценUS $150.15piece
  • Продажная ценаUS $150.15piece
  • ДоставкаБесплатная доставка
  • Рейтинги3,3 (492)

Oписание продукта

MB
Introduction:
compatibility:
  • Compatible with all Futaba FASST 2.4G controls and modules (including gun control, such as 3PK, 4PK)
  • Compatible with FrSky TF Module (TF-8M, TF-14M)
Feature:
  • Compatible with all 2.4G FASST: Compatible with all Futaba FASST 2.4G controls and modules (including gun control, eg 3PK, 4PK);
  • Output CPPM and RSSI: If 3 and 4 channels are connected in parallel with jumpers, 1 channel will output 1-8 channels of CPPM and 2 channels will output RSSI (PMW);
  • lighter weight, smaller size;
  • Two selectable loss-of-control settings.
 
Settings:
Receiver code process:
Open the control, hold the TFR4 receiver\'s F / S button and connect the power. When the red light on the receiver is off, the green light is on, indicating that the code is successful.
 
Out of control protection setting:
The TFR4 receiver has two selectable loss-of-protection options: one that is compatible with the on-board runaway protection setting and the second is the runaway protection set on the TFR4 receiver.
1).In the control of the use of the original runaway protection settings:
If you do not turn off the original control of the runaway protection, TFR4 will use the control of the runaway protection.
2).Set out of control on TFR4:
  • TFR4 supports full-channel runaway protection. Here\'s how to set up TFR4 out of control:
  • TFR4 receiver code is successful, enter the control settings menu, turn off the control of the original runaway protection settings;
  • set any value of the runaway protection in any channel of the TFR4 receiver;
  • Press and hold the F / S button on the TFR4 receiver. When the green light on the receiver flashes twice, it indicates that the runaway protection setting is successful.

If you no longer need this out of control, simply re-code.

Note: TFR4 will give priority to runaway protection if it is not turned off.

 
Receiver mode:
Red light------Green light------mode
          off------on-----------------(normal operation mode)
          on------on-----------------(waiting for code)
Flashing------on -----------------(signal lost)
         on-------flashes twice ---(Fail-Safe setting)
 
How to get CPPM and RSSI from TFR4
If the 3-channel is connected in parallel with the 4-channel jumper, 1 channel will output 1 through 8 CPPMs and 2 channels will output signal strength indicator RSSI (PWM).
 
specification:
Number of channels: 4 channels
Voltage range: 3.5V ~ 10V
Ambient temperature: -10 ℃ ~ 80 ℃
Size: 34 * 19 * 8mm
Weight: 6.2g
HTB1inN_bbsTMeJjSszhq6AGCFXanHTB12mWjb8RRMKJjSZPhq6AZoVXaAHTB17pmXbiERMeJjy0Fcq6A7opXaH